7
SCG3252 | Cisco Nexus 9504 Switch Configuration Guide for Dell SC Series SANs
2.3
Running the basic system configuration
The following steps use the setup utility to configure connectivity for basic management of the system.
After the switch fully reboots, the following prompts will appear:
Abort Power On Auto Provisioning and continue with normal setup ?(yes/no)[n]:
y
---- System Admin Account Setup ----
Do you want to enforce secure password standard (yes/no):
yes
Enter the password for "admin":
my password
Confirm the password for "admin":
my password
---- Basic System Configuration Dialog VDC: 1 ----
This setup utility will guide you through the basic configuration of
the system. Setup configures only enough connectivity for management
of the system.
Please register Cisco Nexus9000 Family devices promptly with your
supplier. Failure to register may affect response times for initial
service calls. Nexus9000 devices must be registered to receive
entitled support services.
Press Enter at anytime to skip a dialog. Use ctrl-c at anytime
to skip the remaining dialogs.
Would you like to enter the basic configuration dialog (yes/no):
yes
Create another login account (yes/no) [n]:
n
Configure read-only SNMP community string (yes/no) [n]:
n
Configure read-write SNMP community string (yes/no) [n]:
n
Enter the switch name :
my switch name
Continue with Out-of-band (mgmt0) management configuration? (yes/no) [y]:
y
Mgmt0 IPv4 address :
my IP address
Mgmt0 IPv4 netmask :
my netmask
Configure the default gateway? (yes/no) [y]:
y
IPv4 address of the default gateway :
my gateway
Configure advanced IP options? (yes/no) [n]:
n
Enable the telnet service? (yes/no) [n]:
y
Enable the ssh service? (yes/no) [y]:
n
Configure the ntp server? (yes/no) [n]:
n
Configure default interface layer (L3/L2) [L2]:
L2
Configure default switchport interface state (shut/noshut) [shut]:
shut
Configure CoPP system profile (strict/moderate/lenient/dense/skip) [strict]:
skip
