Enabling the Fabric Extender Feature Set
You can enable the installed Fabric Extender feature set in any VDC on the device.
Before You Begin
Ensure that you have installed the Fabric Extender feature set in the default VDC.
Ensure that you are in the correct VDC or use the
switchto vdc
command.
SUMMARY STEPS
1.
configure terminal
2.
feature-set fex
3.
exit
DETAILED STEPS
Purpose
Command or Action
Enters configuration mode.
configure terminal
Example:
switch# configure terminal
switch(config)#
Step 1
Enables the Fabric Extender feature set. The feature set must be installed
before it shows as an option to this command.
feature-set fex
Example:
switch(config)# feature-set fex
Step 2
To disable the Fabric Extender feature set, use the
no feature-set fex
command. Before you can disable a feature set, you must install the feature
set in the default VDC.
The
no feature-set fex
command might take some time to complete
if the size of the configuration is very large. The command cleans
up all of the configurations associated with the Fabric Extender
feature set.
Note
Exits configuration mode.
exit
Example:
switch(config)# exit
switch#
Step 3
Disallowing the Fabric Extender Feature Set
By default, when you install the Fabric Extender feature set, it is allowed in all VDCs. You can disallow the
installed Fabric Extender feature set in a specific VDC on the device.
Before You Begin
Ensure that you have installed the feature set in the default VDC.
Cisco Nexus 2000 Series NX-OS Fabric Extender Software Configuration Guide
OL-25816-02
15
Configuring the Fabric Extender
Managing the Fabric Extender Feature Set
