39
Note
For Virtual Gateways, the eth1 address most commonly used is the eth0 address. To prevent
looping, do not connect eth1 to the network until after you have added the CAS to the CAM
in the web console. See the
Cisco NAC Appliance - Clean Access Server Installation and
Configuration Guide, Release 4.5(1)
for further details.
Step 8
Type the subnet mask of the eth1 interface (from field
e.
) or press Enter to accept the default
of 255.255.255.0. Confirm the value at when prompted.
Please enter the netmask for the interface eth1 []: 255.255.255.0
You entered 255.255.255.0, is this correct? (y/n)? [y]
Step 9
Enter the default gateway address for the eth1 untrusted interface (from field
f.
):
•
If the CAS will be a Real-IP or NAT Gateway, this is the IP address of the CAS’s untrusted
interface eth1.
•
If the CAS will be a Virtual Gateway, this can be the same default gateway address used
for the trusted interface.
Please enter the IP address for the default gateway []: 10.10.10.1
You entered 10.10.10.1 Is this correct? (y/n)? [y]
Step 10
At the next prompt, type
n
and press Enter (or just press Enter) to keep VLAN ID passthrough
disabled for the eth1 interface.
[Vlan Id Passthrough] for packets from eth1 to eth0 is disabled.
Would you like to enable it? (y/n)? [n]
Step 11
At the Management VLAN Tagging prompt, type
n
and press Enter (or just press Enter) to
keep Management VLAN tagging disabled (default) for the eth1 interface.
[Management Vlan Tagging] for egress packets of eth1 is disabled.
Would you like to enable it? (y/n)? [n]
Step 12
Type and confirm the host name for the Clean Access Server (from field
g.
). The default
hostname is
nacserver
.
Please enter the hostname [nacserver]: cas3350
You entered cas3350 Is this correct? (y/n)? [y]
Step 13
Type the IP address of the DNS server in your environment (from field
h.
) or accept the default
at the following prompt:
Please enter the IP address for the name server []: 63.93.96.94
You entered 63.93.96.94 Is this correct? (y/n)? [y]
Step 14
Type and confirm the shared secret for the CAM and CAS (from field
i.
) at the prompts.
The shared secret used between Clean Access Manager and Clean Access Server is the
default string: cisco123
