F-21
Cisco MGX 8850 (PXM1E/PXM45), Cisco MGX 8950, Cisco MGX 8830, and Cisco MGX 8880 Configuration Guide
Release 5.0.10, OL-3845-01 Rev. B0, August 16, 2004
Appendix F MPSM Licensing
MPSM Licensing Information
M8850_SF.1.28.MPSM8T1.FRM.a >
On PXM1E and PXM45 platforms, the output of the MPSM dspliccd command also shows if a card is
in slot license alarm. The following example shows the output of the dspliccd command of an
MPSM-8T1-FRM card in a PXM45 platform in the slot license alarm state:
M8850_SF.1.28.MPSM8T1.FRM.a >
dspliccd
Card License Alarm: Minor
Service Module Type: MPSM8T1E1
Service Module Serial Number: SAG07208RRA
Provisioning (addcon) Allowed: YES
=========================================================
Needed License Type Needed Licenses
------------------- ---------------
RateControl 1
=========================================================
Allocated License Type Allocated licenses
---------------------- ------------------
RateControl 1
=========================================================
Programmed License Type Programmed licenses
------------------------ -------------------
RateControl 1
=========================================================
Programmed License Registered: YES
License registration node: M8850_SF
Type <CR> to continue, Q<CR> to stop:
License registration chassis: SCA062300GF
=========================================================
M8850_SF.1.28.MPSM8T1.FRM.a >
Note
If the switch is in node license alarm, you must rekey the PXM license pool before proceeding with any
other license management tasks. (See
“Rekeying Feature Licenses” section on page F-21
.)
When the switch is in slot license alarm, you have a grace period of 5 days (120 hours) to resolve the
alarm(s). During the first 4 days (96 hours), traps are sent every 24 hours. For the final 24 hours of the
grace period, traps are sent every hour of operation. If the alarms do not get cleared, the following actions
are taken:
•
An event is logged indicating the expiration of the grace period for a given slot needing license(s).
•
A trap is sent hourly indicating the expiration of the grace period.
•
The addcon command is blocked on the slot in license alarm until the license alarms are cleared.
When the PXM license pool has been rekeyed or licenses have been added to the PXM license pool,
provisioning is restored and the switch exits the license alarm state.
Rekeying Feature Licenses
Use this procedure to get your node out of the Node License Alarm state.
