Cisco MGX 8830, Configuration Manual

Page: 279 / 642

7-15
Cisco MGX 8850 (PXM1E/PXM45), Cisco MGX 8950, Cisco MGX 8830, and Cisco MGX 8880 Configuration Guide
Release 5.0.10, OL-3845-01 Rev. B0, August 16, 2004
Chapter 7 Managing Service Class Templates
Managing PXM1E Port SCTs
Displaying Port SCT Settings
To view the port SCT settings, use the following procedure.
Step 1 Establish a CLI management session at any user access level.
Step 2 Enter the following command:
mgx8830a.1.PXM.a > dspportsct <abr|bw|gen|cosb|vcThr|cosThr> <ifNum>
Select one of the options to display one of the six SCT configuration reports, and replace <ifNum> with
the number of the port you want to view.
Table 7-6 describes the reports for each of these options.
Note The option names are case sensitive. The switch does not recognize the vcthr option. You must
enter vcThr.
The SCT parameters are divided within SCT files into two groups: VC descriptors and COSB
parameters. A COSB is special memory that temporarily stores incoming or outgoing connection data.
The sections that follow show the display for each of the dspportsct command options and describe the
SCT parameters that appear in the display.
Table 7-6 Options for dspportsct Command
Option Description
abr Displays ABR parameters.
bw Displays bandwidth and policing parameters.
gen Displays general SCT parameters.
cosb Displays COSB parameters.
vcThr Displays virtual circuit threshold parameters.
cosThr Displays COSB threshold parameters.