7-11
Cisco MGX 8850 (PXM1E/PXM45), Cisco MGX 8950, Cisco MGX 8830, and Cisco MGX 8880 Configuration Guide
Release 5.0.10, OL-3845-01 Rev. B0, August 16, 2004
Chapter 7 Managing Service Class Templates
Managing SCTs
Step 6
To verify that the new SCT version has been applied to the appropriate card, enter the dspcd command.
Step 7
To verify that a new port SCT is in use on a card, enter the dspportsct gen <port> command.
Deleting a Registered SCT
When you delete a registered SCT, the SCT is removed from the list of available SCTs and the switch.
The SCT is no longer available to cards that match the SCT card type.
Note
You cannot simply use the addsct command to add a previously deleted SCT. To add a previously deleted
SCT, you must transfer the appropriate SCT file to the switch and then register the SCT.
To delete a registered SCT file from the switch, use the following procedure:
Step 1
Establish a CLI management session at any user access level.
Step 2
Enter the dspscts command to display the registered SCTs and the parameters you will need when
deleting an SCT.
Step 3
At the PXM prompt, enter the delsct <card type> <sct type> <sctid> <major ver> command, as shown
in the following example:
M8830_CH.2.PXM.a >
delsct
pxm1e 1 5 1
Warning: this SCT may be in use on the service modules or the PXM1E. Please verify SCT
usage on these cards by using the "dspports"
Do you want to proceed (Yes/No) ?
y
describes the parameters for the delsct command.
Step 4
Enter the dspscts command to ensure that the proper SCT was deleted from your network.
Table 7-4
delsct Command Parameters
Option
Description
card type
Identifies the type of card the SCT runs on. The possible card
types are as follows:
•
AXSM = axsm or 1
•
AXSME = axsme or 2
•
AXSM-XG = axsmxg or 5
•
FRSM-12-T3E3 = frsm12 or 4
•
MPSM-T3E3-155 = mpsm155 or 6
•
PXM1E = pxm1e or 3
sct type
Specifies whether the SCT is a port SCT or a card SCT.
sct id
Specifies the SCT ID number to be deleted.
major ver
Specifies the major version number of the SCT to be deleted.
