Cisco MGX 8830, Configuration Manual

Page: 128 / 642

2-56
Cisco MGX 8850 (PXM1E/PXM45), Cisco MGX 8950, Cisco MGX 8830, and Cisco MGX 8880 Configuration Guide
Release 5.0.10, OL-3845-01 Rev. B0, August 16, 2004
Chapter 2 Configuring General Switch Features
Verifying the Hardware Configuration
SRME/B 1 or 3 port Service
Redundancy
Module with T3,
SONET, or SDH
interfaces MGX-SMFIR-1-155
MGX-STM1-EL-1
BNC-3T3-M Upper and
lower 7 and 14 15,16, 31,
32 15,16, 31,
32 —
VISM-PR-8E1 8-port E1 Voice
Internetworking
Service Module AX-SMB-8E1
AX-R-SMB-8E1
AX-RJ48-8E1
AX-R-RJ48-8E1
MGX-RJ48-8E1
1
Upper and
lower 3-6, 10-13 1-6, 9-14,
17-22,
25-30
17-22,
25-30 —
VISM-PR-8T1 8-port T1 Voice
Internetworking
Service Module AX-RJ48-8T1
AX-R-RJ48-8T1 Upper and
lower 3-6, 10-13 1-6, 9-14,
17-22,
25-30
17-22,
25-30 —
VXSM-4-155
4
4-port OC-3 Voice
Switch Service
Module VXSM-BC 4-155 Upper and
lower
5
— 1-6, 9-14 1-6, 9-14 —
VXSM-48-
T1E1
4
48-port T1 and E1
Voice Switch
Service Module VXSM-BC 24-T1/E1
VXSM-BC R Upper and
lower — 1-6, 9-14 1-6, 9-14 —
XM60 Switch Module 60
60 Gbps switch
fabric none none — — — 9, 10, 25,
26
1. This card is for use in Australia.
2. Not supported on MGX 8850 (PXM45).
3. SRM-3T3 does not support bulk distribution to 8-port T1 cards in slots 9, 10, 25, and 26. If SRM-3T3 and SRME/B with a T3 interface coexist in the same
bay, bulk distribution for 8-port T1 cards in these slots is not supported. If a SRME/B with a T3 interface is replaced with an SRM-3T3, bulk distribution
for 8-port T1 cards in these slots is not supported.
4. Double-height card.
5. A VXSM back card is installed in the lower bay only when intracard APS is in use.
Table 2-9 Valid Card Installation Options (continued)
Front Card Type Description Back Card Types
Valid Back
Card Bay
Locations MGX 8830
Valid Slot
Numbers MGX 8850
Valid Slot
Numbers MGX 8880
Valid Slot
Numbers MGX 8950
Valid Slot
Numbers