Part Description
Quantity
10-32 x 3/8-in. Phillips pan-head screws
2
12-24 x 3/4-in. Phillips screws
16
10-24 x 3/4-in. Phillips screws
16
Required Equipment
You need the following equipment for this installation:
• Number 2 Phillips screwdriver
• Tape measure and level (to ensure that shelf brackets are at level with each other)
• NEBS plate - If the airflow is port-side intake
Installing the Shelf Bracket Kit into a Two-Post Telco Rack
The following figure shows the installation of the shelf bracket kit into a two-post Telco rack:
Figure 1: Installing the Shelf Bracket Kit into a Telco Rack
10-32 screws
3
Rack-mounting post
1
Crossbar
4
Shelf bracket
2
To install the shelf brackets in a Telco rack, follow these steps:
Step 1
Position a shelf bracket inside a rack-mounting post as shown in and align the screw holes at the front of the shelf bracket
with the holes in the rack-mounting post. Then, attach the shelf bracket to the rack-mounting post using a minimum of
four 12-24 or 10-24 screws.
Installing the Cisco MDS 9220i Switch
3
Installing the Cisco MDS 9220i Switch
Required Equipment