Configuring Cisco MC3810 Series Concentrators to Use High-Performance Compression Modules
Configuration Tasks
6
Cisco IOS Release 12.1(2)T
technology prefix:
ip precedence = 0, UDP checksum = disabled,
session-protocol = cisco, req-qos = best-effort,
acc-qos = best-effort,
fax-rate = voice, payload size = 20 bytes
codec = g711alaw, payload size = 160 bytes,
Expect factor = 10, Icpif = 30,signaling-type = cas,
VAD = enabled, Poor QOV Trap = disabled,
voice class perm tag = `'
Connect Time = 0, Charged Units = 0,
Successful Calls = 0, Failed Calls = 0,
Accepted Calls = 0, Refused Calls = 0,
Last Disconnect Cause is "",
Last Disconnect Text is "",
Last Setup Time = 0.
The following text is sample output from the
show dial-peer voice
command for a VoFR dial peer:
Router#
show dial-peer voice 20
VoiceOverFRPeer20
information type = voice,
tag = 20, destination-pattern = `555....',
answer-address = `', preference=0,
group = 20, Admin state is up, Operation state is up,
incoming called-number = `', connections/maximum = 0/unlimited,
DTMF Relay = disabled,
application associated:
type = vofr, session-target = `Serial0 120',
called number = `',
session-protocol = cisco-switched,
fax-rate = voice, payload size = 30 bytes
codec = g729r8, payload size = 30 bytes,
signaling-type = cas,
VAD = enabled,
Voice Sequence Numbers = disabled,
voice class perm tag = `'
Connect Time = 0, Charged Units = 0,
Successful Calls = 0, Failed Calls = 0,
Accepted Calls = 0, Refused Calls = 0,
Last Disconnect Cause is "",
Last Disconnect Text is "",
Last Setup Time = 0.
The following text is sample output from the
show dial-peer voice
command for a VoATM dial peer:
Router#
show dial-peer voice 1
VoiceOverATMPeer1
information type = voice,
tag = 1, destination-pattern = `555....',
answer-address = `', preference=5,
group = 1, Admin state is up, Operation state is up,
incoming called-number = `', connections/maximum = 0/unlimited,
DTMF Relay = disabled,
application associated:
type = voatm, session-target = `ATM0 pvc 101/1001',
session-protocol = cisco-switched,
fax-rate = voice, payload size = 30 bytes
codec = g729r8, payload size = 30 bytes,
signaling-type = cas,
VAD = enabled,
Voice Sequence Numbers = disabled,
voice class perm tag = `'
Connect Time = 0, Charged Units = 0,
Successful Calls = 0, Failed Calls = 0,
