23
Cisco uBR10-LCP2-MC16C/MC16E/MC16S Cable Interface Card for the Cisco uBR10012 Router
OL-2872-02
Replacing the Line Card in the Cisco uBR10-LCP2 Adapter Card
Note
It is not necessary to configure the cable interface line card if you are installing a replacement card in
the identical slot. The system automatically downloads the necessary configuration information from the
process routing enigne (PRE).
Step 1
Connect all downstream and upstream coaxial cables to the cable interface line card, as necessary.
Step 2
Configure the cable interface line card, if necessary. For information about configuring the cable
interface line card, refer to the
Cisco uBR10012 Universal Broadband Router Software Configuration
Guide
at the following URL:
http://www.cisco.com/en/US/docs/cable/cmts/ubr10012/configuration/guide/scg.html
Replacing the Line Card in the Cisco uBR10-LCP2 Adapter Card
The following section describes how to remove and replace a Cisco uBR-MC16
x
cable interface line card
in the Cisco uBR10-LCP2 adapter card.
Note
Do not attempt to separate or remove the cable interface line card from the Cisco uBR10-LCP2 adapter
card while the combined cards are inserted in the chassis. You must remove the card as a unit; then,
separate the line card from the LCP2 adapter card on a lab bench or other area that protects against ESD
damage.
Tip
To prevent alarms from activating, you must administratively shut down a cable interface line card before
hot swapping it. Refer to the
Cisco uBR7200 Series Universal Broadband Router Software
Configuration Guide
at the following URL:
http://www.cisco.com/en/US/docs/cable/cmts/ubr7200/configuration/guide/cr72scg.html
Otherwise, inform the network administrator that this portion of the network will be temporarily
interrupted. If the maintenance LED is on, you can remove the cable interface line card without affecting
systems operations.
Removing the Cable Interface Line Card from the Adapter Card
Note
The Cisco uBR-MC16S main board also includes a daughter card . This daughter card is an integral part
of the card assembly and cannot be removed in the field.
Step 1
Ensure that you are properly grounded before handling the line card.
Step 2
Remove the cable interface line card from the chassis. See the
“Removing a Cisco uBR10-LCP2-MC16x
Cable Interface Line Card” section on page 17
.
Step 3
Place the cable interface line card on an antistatic surface, omponent side facing up (see
Figure 12
).
