4
Hardware Installation
A
Connect the USB Connector of
the Gigabit USB Adapter to the
USB port of your computer.
To do this, slide the connector
out from it’s holder, unwind the
cable, and connect the
USB
Connector
to the USB port in
your PC.
The Adapter will be automati-
cally detected and installed by
Windows.
Your Windows operating system
may require you to restart your
computer to complete the
installation.
B
Connect an Ethernet cable to
the Ethernet port on the
Adapter, then connect the
other end to the Ethernet port
on the switch or other network-
ing device.
The setup and hardware
insttallation are complete.
B
Install the Hardware
A
Linksys is a registered trademark or trademark of
Cisco Systems, Inc. and/or its affiliates in the U.S.
and certain other countries. Copyright © 2005
Cisco Systems, Inc. All rights reserved.
USB1000-EU-QIG-50406NC BW
For additional information or troubleshooting help, refer
to the User Guide on the Setup CD-ROM. You can also
email for further support.
Website
http://www.linksys.com/international
Registration
http://www.linksys.com/registration
2
