Figure 24. Configurator window heading block
If the unit has been set to
Bridge Mode
, you must set the Bridge ID of the
remote unit to which the local unit must be linked. Set the Bridge ID by
doing the following steps:
1.
Click the
Remote [Unit model] Bridge ID:
drop-down (
Figure 25. General Mode window (Remote Bridge Unit
section)
Click one of the following options:
2.
•
AUTO
: The local unit will automatically establish a wireless
bridge connection with the closest available Cisco unitthat
is set to
Bridge Mode
.
• Alternatively, choose the correct unit from the list of
available units.
3.
Save the operational mode settings by clicking the
Save
button.
Alternatively, clear the settings by clicking the
Reset
button.
Changing the Prodigy version
IMPORTANT
Prodigy version selection is only available if the Cisco FM3200
Base is set to
Mesh Point
mode or
Mesh End
mode. If the
unit is set to
Bridge
mode, the Prodigy Version selector will not
be available.
The
Prodigy Version
box (below) contains the Prodigy version selector.
Device configuration using the configurator interface
© 2021 Cisco and/or its affiliates. All rights reserved.
Page 57 of 176
