Figure 38. Configurator GUI (NTP dialog)
2.
Enable NTP synchronization by checking the
Enable NTP
check-
box.
3.
Enter the host name of a chosen primary NTP server in the
NTP
server hostname:
field.
IMPORTANT
The NTP server host names shown in
are for reference purposes only. Your
company policy may dictate that you use one or more
specific time servers.
4.
If needed, enter the host name of a chosen secondary NTP
server in the
Secondary NTP server (optional):
field.
5.
Select the time zone in which the unit is installed by clicking
the
Select Timezone:
drop-down menu and clicking the correct
time zone option.
6.
Save the NTP settings by clicking the
Save
button. Alternatively,
clear the settings by clicking the
Reset
button.
6.7.8. L2TP configuration
Layer 2 Tunneling Protocol (L2TP) functionality allows Fluidmesh radio
transceivers to support integration with virtual private networks (VPNs).
Fluidmesh hardware devices are shipped from the factory with L2TP
functionality disabled. To change the unit's L2TP settings, do the following
steps:
1.
Click the
-l2tp configuration
link under
ADVANCED SETTINGS
in the left-hand settings menu.
Device configuration using the configurator interface
© 2021 Cisco and/or its affiliates. All rights reserved.
Page 84 of 138
