Cisco Firepower Management Centers, Instructions Manual

Page: 14 / 20

A-14
Cisco Firepower Management Center 750, 1500, 2000, 3500, and 4000 Hardware Installation Guide
Appendix A Memory Upgrade Instructions for Firepower Management Centers
Installing the Processor Air Duct
Figure A-13 Installing a DIMM
What to Do Next:
•
Replace the processor air duct in your Firepower Management Center as described in the “Installing
the Processor Air Duct” section on page A-14 .
Installing the Processor Air Duct
Firepower Management Centers must operate with processor air ducts in place. The air ducts are
required for proper airflow within the chassis. It is necessary to reinstall the air ducts after any
maintenance procedures. There are some differences between chassis models which are described in the
following sections:
•
Installing the Processor Air Duct on Firepower Management Center 750, page A-14
•
Installing the Processor Air Duct on Firepower Management Center 1500 and 3500, page A-16
Installing the Processor Air Duct on Firepower Management Center 750
The procedure for installing the processor air duct on a Firepower MC750 differs depending on the
revision of the appliance (Rev. 1 or Rev. 2). See
Figure A-14 for an illustration of the Firepower MC750
Rev. 1 chassis. See Figure A-15 for an illustration of the Firepower MC750 Rev. 2 chassis.
To install the air duct on a Firepower MC750:
Step 1
Observe the ESD precautions described in Working in an ESD Environment, page A-2 and the safety
precautions described in Safety Warnings, page A-2 .
Step 2
Lower the processor air duct into place.
•
For Rev. 1 chassis, insert the two hooks at the front of the processor air duct into the corresponding
slots on the bracket behind the two system cooling fans (see “1” in
Figure A-14 ).
1
Insert the DIMM
2
Close the latches
103467
2
2
1