Cisco Firepower 1120, Hardware Installation

Page: 38 / 98

38
2. Use the #2 Phillips screwdriver to remove the four large screws (Item 1, Figure 2 on page 38 ) from the chassis base.
Keep the screws. You will replace them at the end of this procedure to mount the bracket on the chassis.
3. Remove only the screws indicated in Figure 2 on page 38 . Do not remove the smaller screws, which secure the
router bottom panel to the chassis.
Figure 2 Remove the Four Large Screws (1) from the Router Base
4. Place the mounting bracket onto the back of the router, following these guidelines ( Figure 3 on page 39 ):

The bracket handle (Item 3, Figure 3 on page 39 ) should be facing the router cable panel.

Align the bracket mounting holes (Item 2, Figure 3 on page 39 ) with the router bracket connectors (Item 1,
Figure 3 on page 39 ). (The screws were removed from the bracket connectors in Step 2.)
302212
Module Panel
Cable Panel
1 1