12
Cisco ENCS 5400-W Series Quick Start Guide
Configuring the ENCS 5400-W Device
Configuring the ENCS 5400-W Device
This section contains the following topics:
•
Adding or Removing RAID-1 for ENCS 5400-W Series
•
CLI Commands Used with ENCS 5400-W
Before You Begin
•
Verify that the specified ENCS 5400 Series chassis (ENCS 5406-W, 5408-W, or 5412-W) is already
installed and powered up. For information on how to install the an ENCS 5400 Series device, see
the
Cisco 5400 Enterprise Network Compute System Hardware Installation Guide
.
•
If you need to add or remove RAID-1 for your system, see
Adding or Removing RAID-1 for ENCS
5400-W Series
. Note that the RAID-1 option is available for vWAAS for WAAS Version 6.4.1a and
later.
Adding or Removing RAID-1 for ENCS 5400-W Series
Note
The RAID-1 option is available for vWAAS for WAAS Version 6.4.1a and later.
Note
Do not swap or replace a drive used by another ENCS system without reformatting it beforehand.
This section contains the following topics:
•
Migrating Equipment from No RAID and 1 SSD to RAID-1 and 2 SSDs
•
Migrating Equipment from RAID-1 and 2 SSDs to No RAID and 1 SSD
Note
For further information on RAID and the ENCS 5400 Series, see the
Cisco 5400 Enterprise Network
Compute System Hardware Installation Guide
.
Migrating Equipment from No RAID and 1 SSD to RAID-1 and 2 SSDs
This section contains two topics:
•
Before You Begin
•
Procedure for Creating the Virtual Disk
Before You Begin
Note
The RAID-1 option is available for vWAAS for WAAS Version 6.4.1a and later.
•
Verify that the supported RAID card has been inserted into the ENCS device.
•
Verify that each slot has an SSD inserted; the SSD is used to perform RAID-1 configuration.
•
Before creating the virtual disk, both drives must be in Unconfigured Good state. If drive is in other
status, use the CIMC Web GUI or CLI and do the following:
