Description
Field
Length of time that the display remains on after turning on at the time that the
Display On Time field specifies.
Enter the value in this field in the format
hours:minutes
.
For example, to keep the display on for 4 hours and 30 minutes after it turns on
automatically, enter
04:30
.
If this field is blank, the phone turns off at the end of the day (0:00).
If Display On Time is 0:00 and the display on duration is blank (or
24:00), the display remains on continuously.
Note
The default value is 10:30.
Display On Duration
EnergyWise on the Cisco Desktop Collaboration Experience Setup
To reduce power consumption, configure the phone to sleep (power down) and wake (power up) if your system
includes an EnergyWise controller.
You configure settings in Cisco Unified Communications Manager Administration to enable EnergyWise and
configure sleep and wake times. These parameters are closely tied to the phone display configuration parameters.
When EnergyWise is enabled and a sleep time is set, the phone sends a request to the switch to wake it up at
the configured time. The switch returns either an acceptance or a rejection of the request. If the switch rejects
the request or if the switch does not reply, the phone does not power down. If the switch accepts the request,
the idle phone goes to sleep, thus reducing the power consumption to a predetermined level. A phone that is
not idle sets an idle timer and goes to sleep after the timer expires.
To wake up the phone press
Lock
. At the scheduled wake time, the system restores power to the phone,
waking it up.
The following table explains the Cisco Unified Communications Manager Administration fields that control
the EnergyWise settings. You configure these fields in Cisco Unified Communications Manager Administration
in the Product Specific Configuration area of the Phone Configuration window
Device
>
Phone
.
Cisco Desktop Collaboration Experience DX650 Administration Guide, Release 10.1(1)
158
EnergyWise on the Cisco Desktop Collaboration Experience Setup
