2-27
Cisco 11000 Series Content Services Switch Hardware Installation Guide
78-15146-02
Chapter 2 Cabling the CSS
Connecting Power Cords
Connecting a CSS 11050 or CSS 11150 AC Power Cord
To connect an AC power cord to a CSS 11050 or CSS 11150:
1.
Ensure that the CSS power switch is in the 0 (off) position.
2.
Attach the power cord to the CSS by plugging the AC power cord connector
into the power receptacle at the rear panel, as shown in
Figure 2-17
.
Figure 2-17 Connecting a CSS 11050 or CSS 11150 AC Power Cord
3.
Plug the power cord into a dedicated 3-wire grounding receptacle.
4.
Switch on the power on the CSS.
Connecting a CSS 11150 DC Power Cord
Before you install a DC power cord, see Appendix A,
Specifications
for DC
power supply safety warnings.
Warning
The DC power supply cord requires 18 AWG wire. The CSS 11150 draws a
maximum of 25 amps.
Warning
DC systems do not have a power switch. A chassis configured for DC power
requires an external power disconnect device (such as an external circuit
breaker).
Power switch
AC power cord
AC -100 -240 VAC
50 - 60HZ 3.1AMax.
49590
