11-2
Cisco x90 Series Content Security Appliances Installation and Maintenance Guide
Chapter 11 Maintain Cisco Content Security Appliances
Prepare for Cisco Content Security Appliance Component Replacement
Prepare for Cisco Content Security Appliance Component
Replacement
•
•
Shut Down and Power Off the Appliance, page 11-2
•
Serial Number Location, page 11-3
•
Hot-Swap Replacement, page 11-3
Required Equipment
The following equipment is used to perform the procedures in this chapter:
•
Number 2 Phillips-head screwdriver
•
Electrostatic discharge (ESD) strap or other grounding equipment such as a grounded mat
Shut Down and Power Off the Appliance
The appliance can run in two power modes:
•
Main power mode—Power is supplied to all appliance components and the operating system.
•
Standby power mode—Power is supplied only to the service processor and the cooling fans and it
is safe to power off the appliance from this mode.
You can gracefully shut down the appliance by using the
shutdown
command or the Power button on
the appliance front panel, as described in the following steps:
Step 1
Check the color of the Power Status LED.
•
Green—The appliance is in main power mode and must be shut down before it can be safely powered
off. Go to
•
Amber—The appliance is already in standby mode and can be safely powered off. Go to
Step 2
Use one the following methods to shut down the appliance. If possible, invoke a graceful shutdown.
Otherwise invoke a hard shutdown:
Caution
To avoid data loss or damage to your operating system, you should always invoke a graceful shutdown
of the operating system.
•
Graceful shutdown using the CLI—Enter the
shutdown
command. The operating system performs
a graceful shutdown and the appliance goes to standby mode, which is indicated by an amber Power
Status LED.
•
Graceful shutdown using the front panel—Press and release the Power button. The operating system
performs a graceful shutdown and the appliance goes to standby mode, which is indicated by an
amber Power Status LED.
•
Emergency shutdown—Press and hold the Power button for 4 seconds to force the main power off
and immediately enter standby mode.
