Cisco CPS-UCS-1RU-K9, User Manual

Page: 25 / 84

1-17
Cisco CSS UCS Platform Series User Guide, CPS-UCS-1RU-K9 / CPS-UCS-2RU-K9
Chapter 1 Overview
Status LEDs and Buttons
Rear Panel LEDs and Buttons
Figure 1-9 shows the rear panel LEDs and buttons.
Figure 1-9 Rear Panel LEDs and Buttons: Cisco Connected Safety and Security UCS C240
PSU1 PSU2
PCIe 1
PCIe 2
PCIe 3
PCIe 4
PCIe 5
3 4 5 6 1 2 7
331829
1 Power supply fault LED 5 1-Gb Ethernet link speed LED
2 Power supply AC OK LED 6 1-Gb Ethernet link status LED
3 1-Gb Ethernet dedicated management link
status LED 7 Identification button/LED
4
1-Gb Ethernet dedicated management link
speed LED –
Table 1-8 defines the LED states.
Table 1-8 Rear Panel LEDs, Definitions of States: Cisco Connected Safety and Security UCS C240
LED Name State
Power supply fault • Off—The power supply is operating normally.
•
Amber, blinking—An event warning threshold has been reached, but the power
supply continues to operate.
• Amber, solid—A critical fault threshold has been reached, causing the power
supply to shut down (for example, a fan failure or an over-temperature condition).
Power supply AC OK • Off—There is no AC power to the power supply.
•
Green, blinking—AC power OK, DC output not enabled.
• Green, solid—AC power OK, DC outputs OK.
1-Gb Ethernet dedicated
management link speed
•
Off—link speed is 10 Mbps.
• Amber—link speed is 100 Mbps.
•
Green—link speed is 1 Gbps.
1-Gb Ethernet dedicated
management link status
•
Off—No link is present.
• Green—Link is active.
•
Green, blinking—Traffic is present on the active link.
1-Gb Ethernet link speed • Off—link speed is 10 Mbps.
•
Amber—link speed is 100 Mbps.
• Green—link speed is 1 Gbps.