Cisco Cisco ONS 15600 SDH, Troubleshooting Manual

Page: 72 / 318

1-40
Cisco ONS 15600 SDH Troubleshooting Guide, R8.0
July 2010
Chapter 1 General Troubleshooting
1.3.4 Create a Terminal Loopback on an Intermediate-Node Ethernet Port
f.
Click Apply .
g. Click Yes in the confirmation dialog box.
Step 6
Complete the “Test and Clear the Ethernet Terminal Loopback Circuit” procedure on page 1-40 .
Test and Clear the Ethernet Terminal Loopback Circuit
Step 1
If the test set is not already sending traffic, send test traffic on the loopback circuit.
Step 2
Examine the test traffic being received by the test set. Look for errors or any other signal information
that the test set is capable of indicating.
Step 3
If the test set indicates a good circuit, no further testing is necessary on the loopback circuit. Clear the
terminal loopback from the port:
a. Double-click the intermediate-node card with the terminal loopback to display the card view.
b.
Click the Maintenance > Ethernet > Loopback > Port tabs.
c. Select None from the Loopback Type column for the port being tested.
d.
Select the appropriate state ( Unlocked ; Locked,disabled ; Locked,maintenance ) in the Admin
State column for the port being tested.
e.
Click Apply .
f.
Click Yes in the confirmation dialog box.
Step 4 Clear the terminal loopback circuit:
a.
Click the Circuits tab.
b. Choose the loopback circuit being tested.
c.
Click Delete .
d.
Click Yes in the Delete Circuits dialog box. Do not check any check boxes.
Step 5
Complete the “Test the ASAP Card” procedure on page 1-40 .
Test the ASAP Card
Step 1 Determine whether you are experiencing trouble on a single SFP (PPM), on all PPMs within a
4PIO (PIM), or on all 4PIO used in that ASAP card. If there is only partial failure, you might be able to
replace this part rather than the entire card.
Step 2
If the errors are being observed on one port but not all ports of the ASAP, you might only need to replace
that SFP (PPM). Remove the errored SFP (PPM) and replace it with a known-good SFP (PPM) by
completing the procedures for this in the “Install Cards and Fiber-Optic Cable” chapter of the
Cisco ONS 15600 SDH Procedure Guide .
Step 3 If all SFPs (PPMs) on a particular 4PIO (PIM) are experiencing problems, the 4PIO (PIM) is indicated.
Remove this 4PIO (PIM) and replace it with a known-good one using the procedures for this in the
“Install Cards and Fiber-Optic Cable” chapter of the
Cisco ONS 15600 SDH Procedure Guide .
Step 4
If the trouble still is not located, complete the “Replace an I/O Card” procedure on page 2-134 for the
suspected bad ASAP card and replace it with a known-good one.