Procedure
To return to the switch CLI, type
exit
from the ASASM privileged or user EXEC mode. If you are in a
configuration mode, enter
exit
repeatedly until you exit the Telnet session.
You return to the switch prompt:
asasm#
exit
Router#
You can alternatively escape the Telnet session using the escape sequence
Ctrl-Shift-6
,
x
; this escape
sequence lets you resume the Telnet session by pressing the
Enter
key at the switch prompt. To
disconnect your Telnet session from the switch, enter
disconnect
at the switch CLI. If you do not
disconnect the session, it will eventually time out according to the ASASM configuration.
Note
Access the Software Module Console
If you have a software module installed, such as the ASA FirePOWER module on the ASA 5506-X, you can
session to the module console.
You cannot access the
hardware
module CLI over the ASA backplane using the
session
command.
Note
Procedure
From the ASA CLI, session to the module:
session
{
sfr
|
cxsc
|
ips
}
console
Example:
ciscoasa# session sfr console
Opening console session with module sfr.
Connected to module sfr. Escape character sequence is 'CTRL-^X'.
Cisco ASA SFR Boot Image 5.3.1
asasfr login:
admin
Password:
Admin123
Access the ASA 5506W-X Wireless Access Point Console
To access the wireless access point console, perform the following steps.
Procedure
Step 1
From the ASA CLI, session to the access point:
session wlan console
CLI Book 1: Cisco ASA Series General Operations CLI Configuration Guide, 9.5
8
Getting Started
Access the Software Module Console
