Cisco CGR2010, Installing And Connecting

Page: 23 / 30

47
Installing and Connecting the Router
Auxiliary Port, Console Port, and Adapter Pinouts for the Cisco CGR 2010 Router
Figure 16 Identifying a Rollover Cable
Table 6 on page 47 shows the RJ-45 rolled (console) cable pinouts:
Console Port Connection to a PC
To connect a PC terminal to the console port, use the RJ-45-to-RJ-45 rollover cable, and either the RJ-45-to-DB-25
female DTE adapter or the RJ-45-to-DB-9 female DTE adapter (labeled
TERMINAL ).
The default parameters for the console port are:

9600 baud

8 data bits

No parity generated or checked

1 stop bit

No Flow Control
Console Port Signaling and Cabling with a DB-9 Adapter
This section describes the console port signaling and cabling with a DB-9 adapter. See Figure 17 on page 48 and
Figure 18 on page 48 ).
Table 6 RJ-45 Rolled Console Cable Pinouts
Signal Pin Pin Signal
- 1 8 -
- 2 7 -
- 3 6 -
- 4 5 -
- 5 4 -
- 6 3 -
- 7 2 -
- 8 1 -
Pin 1
2
3
9780
Pin 8
Pin 1 on one connector a nd
pin 8 on the other connector
s ho u ld b e the sa me color.