6-6
Cisco Content Delivery Engine 205/220/250/280/285/420/460/475 Hardware Installation Guide
Chapter 6 Installing the VQE and Initially Configuring a CDE
Re-Manufacturing a CDE
Figure 6-5
Rebooting the Server
Step 4
Install the VQE Software for CDE280:
a.
Connect to the serial console of CDE280:
–
Enter the IP address of the server with admin as the username and the password previously set.
user1$ ssh -l admin 10.140.104.17
[email protected]'s password: XXXXX
C240-FCH1852V20Y#
–
Enter the following command:
C240-FCH1852V20Y# connect host
Step 5
Power on the CDE.
Once the CD starts booting, it displays a spinning “|” symbol for approximately five minutes. Allow the
booting to proceed and monitor the sequence from a remote terminal provided by the terminal server.
The Installer main menu is displayed at the conclusion of the boot sequence; you should see a menu
similar to this:
Step 6
Un-mount the ISO file:
From the
Virtual Media
tab, select
Activate Virtual Devices
.
Note
When you select
Activate Virtual Devices
, the system prompts whether you want to unmount
the iso file or not.
Step 7
From the Power tab, select
Power Cycle Systems (cold boot)
to reboot the server.
Step 8
To connect to the Console, see
“Connect to the Console” section on page 4-7
.
Installing the VQE Software
To install the VQE software, see
Installing VQE Release 3.11 Software”
section in the
Cisco CDA Visual Quality Experience Application Release 3.11.
