The commands shown in this step start the LECS. The database to use is test. The interface on which the LECS is
configured is atm0.
Step 11
Save the configuration in NVRAM by entering the write memory command, as follows:
Example:
ATM# write memory
Step 12
Start the LEC on the Catalyst 5000 series switches 1 and 2 by entering the interface atm0.1 command and the lane
client tokenring 112 crf112 interface configuration command in configuration mode on the consoles of switches 1 and
2. The interface on which the LEC is configured is atm0.1. The ELAN name is default, and it is configured to emulate
Token Ring. You see the following display:
Example:
ATM# configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
ATM(config)# interface atm0.1
ATM(config-subif)# lane client tokenring 112 crf112
ATM(config-subif)# end
ATM#
Step 13
Save the configuration in NVRAM by entering the write memory command, as follows:
Example:
ATM# write memory
Cisco and the Cisco logo are trademarks or registered trademarks of Cisco and/or its affiliates in the U.S.
and other countries. To view a list of Cisco trademarks, go to this URL:
Third-party trademarks mentioned are the property of their respective owners. The use of the word partner
does not imply a partnership relationship between Cisco and any other company. (1110R)
Any Internet Protocol (IP) addresses and phone numbers used in this document are not intended to be
actual addresses and phone numbers. Any examples, command display output, network topology diagrams,
and other figures included in the document are shown for illustrative purposes only. Any use of actual IP
addresses or phone numbers in illustrative content is unintentional and coincidental.
© 2012 Cisco Systems, Inc. All rights reserved.
Configuring the LES BUS and the LEC Example
33
