Cisco Catalyst 4500 Series, Software Configuration Manual

Page: 804 / 2086

27-8
Catalyst 4500 Series Switch, Cisco IOS Software Configuration Guide - Cisco IOS XE 3.9.xE and IOS 15.2(5)Ex
Chapter 27 Configuring EtherChannel and Link State Tracking
Configuring EtherChannel
These sections describe Layer 3 EtherChannel configuration:
• Creating Port Channel Logical Interfaces, page 27-8
•
Configuring Physical Interfaces as Layer 3 EtherChannels, page 27-8
Creating Port Channel Logical Interfaces
Note
To move an IP address from a physical interface to an EtherChannel, you must delete the IP address from
the physical interface before configuring it on the port channel interface.
To create a port channel interface for a Layer 3 EtherChannel, perform this task:
This example shows how to create port channel interface 1:
Switch# configure terminal
Switch(config)# interface port-channel 1
Switch(config-if)# ip address 172.32.52.10 255.255.255.0
Switch(config-if)# end
This example shows how to verify the configuration of port channel interface 1:
Switch#
show running-config interface port-channel 1
Building configuration...
Current configuration:
!
interface Port-channel1
ip address 172.32.52.10 255.255.255.0
no ip directed-broadcast
end
Switch#
Configuring Physical Interfaces as Layer 3 EtherChannels
To configure physical interfaces as Layer 3 EtherChannels, perform this task for each interface:
Command Purpose
Step 1
Switch(config)# interface port-channel
port_channel_number
Creates the port channel interface. The value for
port_channel_number can range from 1 to 254 for a
standalone switch, and from 1 to 256 for switches in VSS
mode.
Step 2
Switch(config-if)# ip address ip_address mask
Assigns an IP address and subnet mask to the
EtherChannel.
Step 3
Switch(config-if)# end
Exits configuration mode.
Step 4
Switch# show running-config interface
port-channel port_channel_number
Verifies the configuration.