Cisco Catalyst 4500 Series, Software Configuration Manual

Page: 1443 / 2086

C H A P T E R
53-1
Catalyst 4500 Series Switch, Cisco IOS Software Configuration Guide - Cisco IOS XE 3.9.xE and IOS 15.2(5)Ex
53
Configuring Wired Guest Access
This chapter describes the tasks for configuring wired guest access on a Catalyst 4500 series switch and
includes these major sections:
•
Wired Guest Access, page 53-1
• Information about Wired Guest Access, page 53-2
•
How to Configure Wired Guest Access, page 53-4
• Configuration Examples for Wired Guest Access, page 53-6
Note For complete syntax and usage information for the switch commands used in this chapter, see the
Cisco IOS Command Reference Guides for the Catalyst 4500 Series Switch .
If a command is not in the Cisco Catalyst 4500 Series Switch Command Reference , you can locate it in
the Cisco IOS Master Command List, All Releases .
Note
To identify the hardware platform or software image information associated with a feature, use the
Feature Navigator on Cisco.com to search for information about the feature or refer to the software
release notes for a specific release.
Wired Guest Access
The Wired Guest Access feature enables guest users of an enterprise network that supports both wired
and wireless access to connect to the guest access network from a wired Ethernet connection. The wired
Ethernet connection is designated and configured for guest access. Wired session guests on mobility
agents are directed to a wireless guest controller in a demilitarized zone (DMZ) through a Control And
Provisioning of Wireless Access Points (CAPWAP) tunnel.
Wired guest access can be configured in a dual-controller configuration that uses both an anchor
controller and a foreign controller. A dual-controller configuration isolates wired guest access traffic.
Restrictions for Wired Guest Access
•
Wired guest access does not work on Supervisor Engine 8-E, in multiple-host mode or in multi-
authentication mode.