2-404
Catalyst 3750 Metro Switch Command Reference
OL-9645-10
Chapter 2 Catalyst 3750 Metro Switch Cisco IOS Commands
rep stcn
rep stcn
Use the
rep stcn
interface configuration command on a Resilient Ethernet Protocol (REP) edge port to
configure the port to send REP segment topology change notifications (STCNs) to another interface, to
other segments, or to Spanning Tree Protocol (STP) networks. Use the
no
form of this command to
disable the sending of STCNs to the interface, segment, or STP network.
rep stcn
{
interface
interface-id
|
segment
id-list
|
stp
}
no rep stcn
{
interface
|
segment
|
stp
}
Syntax Description
Defaults
Transmission of STCNs to other interfaces, segments, or STP networks is disabled.
Command Modes
Interface configuration
Command History
Usage Guidelines
Enter this command on a segment edge port.
You use this command to notify other portions of the Layer 2 network of topology changes that occur in
the local REP segment. This removes obsolete entries in the Layer 2 forwarding table in other parts of
the network, which allows faster network convergence.
Examples
This example shows how to configure a REP edge port to send STCNs to segments 25 to 50:
Switch (config)#
interface gigabitethernet1/0/2
Switch (config-if)#
rep stcn segment 25-50
Switch (config-if)#
exit
You can verify your settings by entering the
show interfaces rep detail
privileged EXEC command.
interface
interface-id
Identify a physical interface or port channel to receive STCNs.
segment
id-list
Identify one REP segment or list of segments to receive STCNs. The range is 1
to 1024. You can also configure a sequence of segments (for example 3-5, 77,
100).
stp
Send STCNs to an STP network.
Release
Modification
12.2(40)SE
This command was introduced.
