Purpose
Command or Action
Sets the role of the device attached to the port.
device-role
{
host
|
monitor
|
router
|
switch
}
Example:
Device(config-nd-raguard)#
device-role router
Step 5
Configuring Non-IP Wireless Multicast (CLI)
SUMMARY STEPS
1.
enable
2.
configure terminal
3.
wireless multicast non-ip
4.
wireless multicast non-ip vlanid
5.
end
DETAILED STEPS
Purpose
Command or Action
Enables privileged EXEC mode.
enable
Step 1
Example:
Device>
enable
•
Enter your password if prompted.
Enters global command mode.
configure terminal
Example:
Device#
configure terminal
Step 2
Enables non-IP multicast in all VLANs. Default value is
enable
.
Wireless multicast must be enabled for the traffic to pass. Add
no
in the command to disable the non-IP multicast in all VLANs.
wireless multicast non-ip
Example:
Device(config)#
wireless multicast non-ip
Step 3
Device(config)#
no wireless multicast
non-ip
Enables non-IP multicast per VLAN. Default value is
enable
. Both
wireless multicast and wireless multicast non-IP must be enabled
wireless multicast non-ip vlanid
Example:
Device(config)#
wireless multicast non-ip
5
Step 4
for traffic to pass. Add
no
in the command to disable the non-IP
multicast per VLAN.
Device(config)#
no wireless multicast
non-ip 5
IP Multicast Routing Configuration Guide, Cisco IOS XE Release 3SE (Catalyst 3650 Switches)
OL-29890-01
223
Configuring Wireless Multicast
Configuring Non-IP Wireless Multicast (CLI)
