Cisco Catalyst 3650 Series, Command Reference Manual

Page: 910 / 1108

switch renumber
To change the stack member number, use the switch renumber command in EXEC mode on the active switch.
switch current-stack-member-number renumber new-stack-member-number
Syntax Description
Current stack member number. The range is 1 to 9. current-stack-member-number
New stack member number for the stack member. The range
is 1 to 9. new-stack-member-number
Command Default
The default stack member number is 1.
Command Modes
User EXEC
Privileged EXEC
Command History
Modification Release
This command was introduced. Cisco IOS XE 3.3SECisco IOS XE 3.3SE
Usage Guidelines
If another stack member is already using the member number that you just specified, the active switch assigns
the lowest available number when you reload the stack member.
If you change the number of a stack member, and no configuration is associated with the new stack member
number, that stack member loses its current configuration and resets to its default configuration.
Note
Do not use the switch current-stack-member-number renumber new-stack-member-number command on a
provisioned switch. If you do, the command is rejected.
Use the reload slot current stack member number privileged EXEC command to reload the stack member
and to apply this configuration change.
Examples This example shows how to change the member number of stack member 6 to 7:
Device# switch 6 renumber 7
WARNING:Changing the switch number may result in a configuration change for that switch.
The interface configuration associated with the old switch number will remain as a provisioned
configuration.
Do you want to continue?[confirm]
Command Reference, Cisco IOS XE Everest 16.5.1a (Catalyst 3650 Switches)
884
switch renumber