Cisco Catalyst 3650 Series, Command Reference Manual

Page: 243 / 1108

ip igmp filter
To control whether or not all hosts on a Layer 2 interface can join one or more IP multicast groups by applying
an Internet Group Management Protocol (IGMP) profile to the interface, use the
ip igmp filter interface
configuration command on the device stack or on a standalone device. To remove the specified profile from
the interface, use the
no form of this command.
ip igmp filter profile number
no ip igmp filter
Syntax Description
The IGMP profile number to be applied. The range is 1 to 4294967295. profile number
Command Default
No IGMP filters are applied.
Command Modes
Interface configuration
Command History
Modification Release
This command was introduced. Cisco IOS XE 3.3SECisco IOS XE 3.3SE
Usage Guidelines
You can apply IGMP filters only to Layer 2 physical interfaces; you cannot apply IGMP filters to routed ports,
switch virtual interfaces (SVIs), or ports that belong to an EtherChannel group.
An IGMP profile can be applied to one or more device port interfaces, but one port can have only one profile
applied to it.
Examples You can verify your setting by using the show running-config privileged EXEC command and by specifying
an interface.
Command Reference, Cisco IOS XE Everest 16.5.1a (Catalyst 3650 Switches)
217
ip igmp filter