Cisco Catalyst 3560-X Series, Software Configuration Manual

Page: 679 / 1538

1-27
Catalyst 3750-X and 3560-X Switch Software Configuration Guide
OL-25303-03
Chapter 1 Configuring DHCP Features and IP Source Guard
Configuring DHCP Server Port-Based Address Allocation
Configuring DHCP Server Port-Based Address Allocation
• Default Port-Based Address Allocation Configuration, page 1-27
•
Port-Based Address Allocation Configuration Guidelines, page 1-27
• Enabling DHCP Server Port-Based Address Allocation, page 1-27
Default Port-Based Address Allocation Configuration
By default, DHCP server port-based address allocation is disabled.
Port-Based Address Allocation Configuration Guidelines
• Only one IP address can be assigned per port.
•
Reserved addresses (preassigned) cannot be cleared by using the clear ip dhcp binding global
configuration command.
• Preassigned addresses are automatically excluded from normal dynamic IP address assignment.
Preassigned addresses cannot be used in host pools, but there can be multiple preassigned addresses
per DHCP address pool.
•
To restrict assignments from the DHCP pool to preconfigured reservations (unreserved addresses are
not offered to the client and other clients are not served by the pool), you can enter the
reserved-only
DHCP pool configuration command.
Enabling DHCP Server Port-Based Address Allocation
Beginning in privileged EXEC mode, follow these steps to globally enable port-based address allocation
and to automatically generate a subscriber identifier on an interface.
Command Purpose
Step 1
configure terminal Enter global configuration mode.
Step 2
ip dhcp use subscriber-id client-id Configure the DHCP server to globally use the
subscriber identifier as the client identifier on all
incoming DHCP messages.
Step 3 ip dhcp subscriber-id interface-name Automatically generate a subscriber identifier based
on the short name of the interface.
A subscriber identifier configured on a specific
interface takes precedence over this command.
Step 4
interface interface-id Specify the interface to be configured, and enter
interface configuration mode.
Step 5 ip dhcp server use subscriber-id client-id Configure the DHCP server to use the subscriber
identifier as the client identifier on all incoming
DHCP messages on the interface.
Step 6 end Return to privileged EXEC mode.