Cisco Catalyst 3550, Installation Manual

Page: 69 / 154

2-19
Catalyst 3550 Multilayer Switch Hardware Installation Guide
78-11358-03
Chapter 2 Installing and Starting the Switch
Installing the Switch
Wall Mounting
To install the switch on a wall, follow the instructions in these procedures:
• Attaching the Brackets to the Switch for Wall-Mounting, page 2-19
•
Attaching the RPS Connector Cover, page 2-20
• Mounting the Switch on a Wall, page 2-21
Note The illustrations in this section show the Catalyst 3550-12T switch as an example.
All the Catalyst 3550 switches are wall-mounted following the same procedures.
Attaching the Brackets to the Switch for Wall-Mounting
Figure 2-17 shows how to attach a 19-inch bracket to one side of the switch.
Follow the same steps to attach the second bracket to the opposite side.
Figure 2-17 Attaching the 19-inch Brackets for Wall-Mounting
Note
Before you attach the brackets on the Catalyst 3550-24-FX switch, remove the
screws that are in the middle of the chassis. Attach the bracket by using the
supplied Phillips flat-head screws, as shown in
Figure 2-17 .
100-240V~
5-3A
50/60Hz
CONSOLE
51368
Phillips
truss-head
screws