7-54
Cisco Catalyst Blade Switch 3130 and 3032 for Dell Software Configuration Guide
OL-12247-04
Chapter 7 Configuring Switch-Based Authentication
Configuring the Switch for Secure Socket Layer HTTP
Use the
no
crypto ca trustpoint
name
global configuration command to delete all identity information
and certificates associated with the CA.
Configuring the Secure HTTP Server
If you are using a certificate authority for certification, you should use the previous procedure to
configure the CA trustpoint on the switch before enabling the HTTP server. If you have not configured
a CA trustpoint, a self-signed certificate is generated the first time that you enable the secure HTTP
server. After you have configured the server, you can configure options (path, access list to apply,
maximum number of connections, or timeout policy) that apply to both standard and secure HTTP
servers.
Beginning in privileged EXEC mode, follow these steps to configure a secure HTTP server:
Step 7
enrollment http-proxy
host-name
port-number
(Optional) Configure the switch to obtain certificates from the CA
through an HTTP proxy server.
Step 8
crl query
url
Configure the switch to request a certificate revocation list (CRL) to
ensure that the certificate of the peer has not been revoked.
Step 9
primary
(Optional) Specify that the trustpoint should be used as the primary
(default) trustpoint for CA requests.
Step 10
exit
Exit CA trustpoint configuration mode and return to global configuration
mode.
Step 11
crypto ca authentication
name
Authenticate the CA by getting the public key of the CA. Use the same
name used in Step 5.
Step 12
crypto ca enroll
name
Obtain the certificate from the specified CA trustpoint. This command
requests a signed certificate for each RSA key pair.
Step 13
end
Return to privileged EXEC mode.
Step 14
show crypto ca trustpoints
Verify the configuration.
Step 15
copy running-config startup-config
(Optional) Save your entries in the configuration file.
Command
Purpose
Command
Purpose
Step 1
show ip http server status
(Optional) Display the status of the HTTP server to determine if the
secure HTTP server feature is supported in the software. You should see
one of these lines in the output:
HTTP secure server capability: Present
or
HTTP secure server capability: Not present
Step 2
configure terminal
Enter global configuration mode.
Step 3
ip http secure-server
Enable the HTTPS server if it has been disabled. The HTTPS server is
enabled by default.
Step 4
ip http secure-port
port-number
(Optional) Specify the port number to be used for the HTTPS server. The
default port number is 443. Valid options are 443 or any number in the
range 1025 to 65535.
