5-24
Cisco Catalyst Blade Switch 3130 and 3032 for Dell Software Configuration Guide
OL-12247-04
Chapter 5 Managing Switch Stacks
Configuring the Switch Stack
This example shows how to configure the persistent MAC address feature for a 7-minute time delay and
to verify the configuration:
Switch(config)#
stack-mac persistent timer 7
WARNING: The stack continues to use the base MAC of the old Master
WARNING: as the stack MAC after a master switchover until the MAC
WARNING: persistency timer expires. During this time the Network
WARNING: Administrators must make sure that the old stack-mac does
WARNING: not appear elsewhere in this network domain. If it does,
WARNING: user traffic may be blackholed.
Switch(config)
# end
Switch#
show switch
Switch/Stack Mac Address : 0016.4727.a900
Mac persistency wait time: 7 mins
H/W Current
Switch# Role Mac Address Priority Version State
----------------------------------------------------------
*1 Master 0016.4727.a900 1 0 Ready
Assigning Stack Member Information
These sections describe how to assign stack member information:
•
Assigning a Stack Member Number, page 5-24
(optional)
•
Setting the Stack Member Priority Value, page 5-25
(optional)
•
Provisioning a New Member for a Switch Stack, page 5-25
(optional)
Assigning a Stack Member Number
Note
This task is available only from the stack master.
Beginning in privileged EXEC mode, follow these steps to assign a member number to a stack member.
This procedure is optional.
Command
Purpose
Step 1
configure terminal
Enter global configuration mode.
Step 2
switch
current-stack-member-number
renumber
new-stack-member-number
Specify the current stack member number and the new stack member
number for the stack member. The range is 1 to 9.
You can display the current stack member number by using the
show
switch
user EXEC command.
Step 3
end
Return to privileged EXEC mode.
Step 4
reload slot
stack-member-number
Reset the stack member.
Step 5
show switch
Verify the stack member number.
Step 6
copy running-config startup-config
Save your entries in the configuration file.
