Procedure
Step 1
In the
Device ID and Location Settings
section, type a unique name to identify your device in the network.
Step 2
Choose the date and time settings for your device. To synchronize your device with a valid outside timing
mechanism, such as an NTP clock source, choose Automatic, or choose Manual to set it yourself.
Figure 39: Basic Settings - Device ID and Location Settings
Step 3
In the
Device Management Settings
section, assign an
IP address
to the management interface. Ensure
that the IP address you assign is part of the subnet mask you enter.
Step 4
Optionally, enter an
IP address
to specify the default gateway.
Step 5
To enable access to the device using telnet, check the
Telnet
check box.
Step 6
To enable secure remote access to the device using Secure Shell (SSH), check the
SSH
check box.
Step 7
Check the
VTP transparent mode
check box to disable the device from participating in VTP.
If you did not select
Wired Network
, in the earlier step, continue to the next screen to verify your configuration
on the
Day 0 Config Summary
screen, and click
Finish
. To automatically configure your device based on
a site profile, click
Setup Options
, and select
Wired Network
.
Cisco Catalyst 9200 Series Switches Hardware Installation Guide
58
Configuring the Switch
Configuring Basic Device Settings
Summary of Contents for C9200L-24P-4G
Page 2: ... 2018 2020 Cisco Systems Inc All rights reserved ...
Page 94: ......
