Cisco C390, Quick Start Manual

Page: 9 / 16

9
Log In to the Appliance
You can log in to the Cisco C390 appliance using one of two interfaces: the
web-based interface or the command-line interface.
Web-Based Interface
Step 1
For web browser access via the Ethernet port (see the “Connect to the
Appliance” section on page 7 ), go to the appliance’s management
interface by entering the following URL in a web browser:
http://192.168.42.42
Step 2
Log in with the following credentials:
•
Username: admin
•
Password: ironport
Command-Line Interface
Step 1
Access the command-line interface locally or remotely:
•
To access the CLI locally, set up a terminal to connect to the serial
port using 9600 bits, 8 bits, no parity, 1 stop bit (
9600, 8, N, 1 ) and
flow control set to Hardware. To physically connect the terminal,
see the
“Connect to the Appliance” section on page 7 ).
•
To access the CLI remotely, initiate an SSH session to the IP address
192.168.42.42 .
Step 2
Log in as admin with the password ironport .
Step 3
At the prompt, run the systemsetup command.