1-24
Cisco BTS 10200 Softswitch ISDN Provisioning and Troubleshooting
OL-12436-02
Chapter 1 ISDN Provisioning
ISDN PRI PBX Variant Setup
ISDN PRI PBX Variant Setup
The ISDN PRI implementation enhances the Cisco BTS 10200 Softswitch by allowing interconnection
to small and medium businesses using legacy PBX PRI interfaces. The design provides for the transport
of additional PRI Information Elements (IEs) and two messages. The IEs include high layer
compatibility (HLC), low layer compatibility (LLC), redirecting number (RGN), original called number
(OCN), and Connected Number (CN). Message support is also provided for NOTIFY messages, and
supplementary service support is provided for the Calling Name feature.
The Cisco BTS 10200 Softswitch supports the following PRI variants:
•
Nortel DMS-100
•
Lucent-5ESS
•
AT&T-4ESS
•
NI2
Note
The proprietary-supp token must be set to 8 when provisioning NI2.
The following sections provide the provisioning steps for specific PBXs. The steps are executed by using
the Cisco BTS 10200 Softswitch CLI. For more information about using the CLI, see the
Cisco BTS
10200 Softswitch Command Line Interface Guide
.
lists the switch vendors, protocol, the section, and the page of the configuration example.
Table 1-3
Switch Vendors, Protocol and Configuration Examples
Switch Vendor
NI2
DMS-100
4ESS
5ESS
Lucent
Lucent Definity
G3r with NI2,
page 1-26
Lucent Definity
G3r with
DMS-100,
page 1-26
Unknown
Lucent Definity
G3r with 5ESS,
page 1-26
Nortel
Nortel Option 11
with NI2,
page 1-27
Nortel Northstar
with NI2,
page 1-27
Nortel Option 11
with DMS-100,
page 1-27
Unknown
Unknown
Intertel
Intertel 256 with
NI2, page 1-25
Intertel 256 with
DMS-100,
page 1-25
Intertel 256 with
4ESS, page 1-25
Intertel 256 with
5ESS, page 1-25
Siemans
Siemens Hicom
300 with NI2,
page 1-27
(New)
Siemens Hicom
300 with
DMS-100,
page 1-27
Siemens Hicom
300 with 4ESS,
page 1-28
Siemens Hicom
300 with 5ESS,
page 1-28
Toshiba
Toshiba Strada
DK424 with NI2,
page 1-28
Unknown
Unknown
Unknown
