![background image](http://html.mh-extra.com/html/cisco/asr-9000-series/asr-9000-series_command-reference-manual_64844468.webp)
frame-relay multilink ack
To configure the MFR acknowledge timeout value for a Frame Relay multilink bundle link, use the
frame-relay
multilink ack
command in interface configuration mode. To revert to the default settings, use the
no
form
of this command.
frame-relay multilink ack ack-timeout
no frame-relay multilink ack
Syntax Description
Ack timeout value, in seconds. The range is from 1 to 10.
ack-timeout
Command Default
The default MFR acknowledge timeout value is 4 seconds.
Command Modes
Interface configuration
Command History
Modification
Release
This command was introduced.
Release 4.0.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
The
frame-relay multilink ack
command is supported only on serial interfaces. The
frame-relay multilink
ack
command is not supported on Packet-over-SONET/SDH (POS) or multilink frame relay interfaces.
Note
The
frame-relay multilink ack
command can be configured only on bundle link interfaces that have been
associated with a bundle using the
encapsulation frame-relay mfr
command.
You can enter the
frame-relay multilink ack
command at any time without affecting the current state of
the interface; however, the configured timeout value does not go into effect until the interface has gone
from the down state to the up state. One way to bring the interface down and back up again is by using
the
shutdown
and
no shutdown
commands in interface configuration mode.
Note
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
448
Frame Relay Commands on the Cisco ASR 9000 Series Router
frame-relay multilink ack