2-10
Cisco ASR 14000 Series Router 8-Slot Line Card Chassis Installation Guide
OL-16973-01
Chapter 2 Installing and Removing Power Components
How to Install or Remove the Power Components
Note
Although there are differences between the different power module types (AC and DC), they are installed
in the same manner.
Installing a PDU
This section describes how to install a PDU in the Cisco ASR 14000 series 8-slot line card chassis. For
information on the difference between the power types, see the
“DC Power Systems” section on page 2-4
and the
“AC Power Systems” section on page 2-8
. For complete information on regulatory compliance
and safety, see
Regulatory Compliance and Safety Information for the Cisco ASR14000 Series
Aggregation Services Router
.
The PDU is installed into the back of the chassis. After the PDU is installed, you can slide the power
modules into the chassis and connect them to the PDU to provide power to the chassis (see the
a Power Module” section on page 2-13
for details). Although there are differences among the different
PDU types (AC Wye, AC Delta, and DC), they are installed in the same manner. (
shows an
AC Wye PDU for reference.)
Figure 2-6
AC Wye PDU
Prerequisites
Before performing this task, remove any front cosmetic covers.
Required Tools and Equipment
You need the following tools and part to perform this task:
•
ESD-preventive wrist strap
•
10-mm socket wrench
•
8-mm socket or open (box end) wrench
•
PDU
122288
