d) Place the cover aside while wearing an antistatic device, such as a wrist strap.
Step 3
Position the chassis so that you are facing the front of the chassis to remove the DIMM.
Step 4
Locate the DIMM on the ASR 1001 Router. See Figure 14-20, callout 1.
Step 5
Pull down the lever on the DIMM socket to release the corresponding DIMM from the socket. See the following figure.
Figure 248: DIMM Socket Release Lever to Remove the DIMM from the Cisco ASR 1001 Router
Step 6
When one end of the DIMM is released from the socket, grasp each end of the DIMM with your thumb and forefinger
and pull the DIMM completely out of the socket. Handle only the edges of the DIMM; avoid touching the memory
module, pins, and the metal traces (the metal fingers along the connector edge of the DIMM) along the socket edge.
Step 7
Place the DIMM in an antistatic bag to protect it from ESD damage.
Step 8
Repeat Step 8 through Step 10 for the remaining DIMMs if required for your upgrade.
What to Do Next
This completes the steps for removing the Cisco ASR 1001 Router DIMMs from the chassis.
Replacing the Cisco ASR 1001 Router DIMM
This section lists the steps to replace a DIMM into the Cisco ASR 1001 Router.
Cisco ASR 1000 Series Router Hardware Installation Guide
511
Removing and Replacing FRUs from the Cisco ASR 1000 Series Routers
Removing and Replacing the Cisco ASR 1001 Router DIMM Memory Modules
Summary of Contents for ASR 1001
Page 2: ... 2013 2017 Cisco Systems Inc All rights reserved ...
Page 20: ...Cisco ASR 1000 Series Router Hardware Installation Guide xx Contents ...
Page 30: ...Cisco ASR 1000 Series Router Hardware Installation Guide xxx Preface Warning Definition ...
Page 32: ...Cisco ASR 1000 Series Router Hardware Installation Guide xxxii Preface Warning Definition ...
