Cisco ASR 1001, Hardware Installation Manual

Page: 396 / 702

Step 9 After inserting the ground wire, leave an extra service loop in the ground lead, as shown in Figure 175: Cisco +24 VDC
Power Supply Terminal Block Ground Lead Service Loop, on page 362 to ensure that the ground lead is the last lead to
disconnect from the power supply if a great deal of strain is placed on all three leads.
Figure 175: Cisco +24 VDC Power Supply Terminal Block Ground Lead Service Loop
+24 VDC power supply
Standby switch 4 Ground lead wire with
service loop 1
Power supply tabs 5 Negative lead wire 2
— — Positive lead wire 3
Step 10
After tightening the receptacle screw for the ground, and leaving the extra service loop in the ground lead, use a cable
tie to secure the three leads to the power supply faceplate tie-wrap tab, as shown in
Figure 175: Cisco +24 VDC Power
Supply Terminal Block Ground Lead Service Loop, on page 362 , item 5.
Step 11 Turn on the branch source breaker.
Step 12
Move the power supply Standby switch to the On (|) position. The power supply LEDs light when power is supplied to
the router.
What to Do Next
This completes the steps for installing the +24 VDC power supply in the Cisco ASR 1002-X Router.
Connecting a Terminal to the Console Port
The integrated route processor has an asynchronous serial (EIA/TIA-232) RJ-45 console port labeled CON
on its front panel. You can connect this port to most types of video terminals using the console cable kit that
is included with your Cisco ASR 1002-X Router. The console cable kit contains:
• One RJ-45-to-RJ-45 crossover cable
• One RJ-45-to-DB-9 (female) adapter
A crossover cable reverses pin connections from one end to the other. In other words, it connects pin 1 (at
one end) to pin 8 (at the other end), pin 2 to pin 7, pin 3 to pin 6, and so on. You can identify a crossover cable
by comparing the two modular ends of the cable. Hold the cable ends in your hand, side-by-side, with the
tabs at the back. Ensure that the wire connected to the outside (left) pin of the left plug (pin 1) is the same
color as the wire connected to the outside (right) pin of the right plug (pin 8).
Use the following procedure to connect a video terminal to the console port on a route processor.
Cisco ASR 1000 Series Router Hardware Installation Guide
362
Cisco ASR 1002-X Router Overview and Installation
Connecting a Terminal to the Console Port