5
Cisco Aironet 14-dBi Vertically Polarized Sector Antenna (AIR-ANT2414S-R)
78-16403-01
Generally, the higher an antenna is above the ground, the better it performs. Good practice is to install
your antenna about 5 to 10 ft (1.5 to 3 m) above the roof line and away from all power lines and
obstructions. If possible, find a mounting place directly above your wireless device so that the lead-in
cable can be as short as possible.
Hardware, Tools, and Fasteners Required
A mast mounting installation kit is shipped with the antenna and consists of the following hardware.
•
Upper mounting bracket (adjustable)
•
Lower mounting bracket (fixed)
•
Mast mount clamps
•
Four 4.0-in. (10.1 cm) ¼-20 hex head bolts with flat washers, split lock washers, and hex nuts
•
Four ¾-in. (1.9 cm) ¼-20 hex head bolts with flat washers, split lock washers, and hex nuts
•
Four ¼-20 hex nuts with split lock washers
You will need two 7/16-in. deep well sockets or wrenches to install the antenna.
Figure 1
shows the
mounting bracket assembly.
Installation Process
The following sections contains typical procedures for installing the antenna on a mast. Your installation
may vary. The process consists of the following procedures.
•
Assembling the mounting brackets
•
Attaching the mounting brackets to the antenna
•
Mounting the antenna
•
Aligning the antenna
•
Grounding the antenna
Before you begin, refer to
Figure 1
and
Figure 2
to become familiar with the installation.
Assembling the Mounting Brackets
Two mounting brackets are provided; one is adjustable and the other is not.
Figure 1
shows the adjustable
bracket. The assembly process is the same for both brackets. Follow these steps to assemble the
mounting brackets.
Step 1
Position the mast mount clamp plate inside the antenna bracket.
Step 2
Insert two ¼-20x ¾-in. hex head bolts into the holes in the mast mount clamp plate facing outward as
shown in
Figure 1
.
Step 3
Place a flat washer and split lock washer on each hex head bolt.
Step 4
Start a ¼-20 hex nut on each hex head bolt and tighten hand tight.
Step 5
Place a flat washer on two 4-inch ¼-20 hex head bolts.
Step 6
Insert the bolts into the holes facing outward in the mast mount clamp plate.
