Cisco AIR-AP1251AG-A-k9, Hardware Installation Manual

Page: 64 / 140

C I S C O C O N F I D E N T I A L - D r a f t A 1
3-4
Cisco Aironet 1250 Series Access Point Hardware Installation Guide
OL-8247-02
Chapter 3 Troubleshooting 1250 Series Autonomous Access Points
Checking the Power Injector LEDs
Checking the Power Injector LEDs
The power injector (model:AIR-PWRINJ4) has three LEDs on the top end of the case (see Figure 3-2 ).
Figure 3-2 Power Injector LEDs
Boot loader errors Red Red Red DRAM memory test failure.
Off Blinking red
and blue Red Flash file system failure.
Off Alternating red
and green Amber Environment variable (ENVAR) failure.
Amber Rapid blinking
red Off Bad MAC address.
Red Blinking red
and off Off Ethernet failure during image recovery.
Amber Blinking red
and off Amber Boot environment error.
Red Blinking red
and off Amber No Cisco IOS image file.
Amber Blinking red
and off Amber Boot failure.
Cisco IOS errors Blinking amber — — Transmit or receive Ethernet errors.
— — Blinking amber Maximum retries or buffer full occurred on the
radio.
Red Off Red Software failure; try disconnecting and
reconnecting unit power.
— Cycle through
blue, green,
red, and off — General warning, insufficient inline power (see
the
“Low Power Condition on Autonomous
Access Points” section).
Table 3-1 Autonomous Access Point LED Signals (continued)
Message type Ethernet LED Status LED Radio LED Meaning
AP POWER FAULT AC POWER
170366