C I S C O C O N F I D E N T I A L - D r a f t A 1
E-2
Cisco Aironet 1250 Series Access Point Hardware Installation Guide
OL-8247-02
Appendix E Console Cable Pinouts
Overview
Overview
The access point requires a special serial cable that connects the access point serial console port (RJ-45
connector) to your PC’s COM port (DB-9 connector). This cable can be purchased from Cisco (part
number AIR-CONCAB1200) or can be built using the pinouts in this appendix.
Console Port Signals and Pinouts
Use the console RJ-45 to DB-9 serial cable to connect the access point’s console port to the COM port
of your PC running a terminal emulation program.
Note
Both the Ethernet and console ports use RJ-45 connectors. Be careful to avoid accidently connecting the
serial cable to the Ethernet port connector.
Note
After completing your configuration changes, you must remove the serial console cable from the access
point.
lists the signals and pinouts for the console RJ-45 to DB-9 serial cable.
Table E-1
Signals and Pinouts for a Console RJ-45 to DB-9 Serial Cable
Console Port
PC COM Port
RJ-45
DB-9
Pins
Signals
Pins
Signals
1
NC
1
1.
NC indicates not connected.
–
–
2
NC
1
–
–
3
TXD
2
2.
TXD indicates transmit data.
2
RXD
3
3.
RXD indicates receive data.
4
GND
4
4.
GND indicates ground.
5
GND
4
5
GND
3
5
GND
4
6
RXD
5
3
TXD
2
7
NC
1
–
–
8
NC
1
–
–
