10
Quick Start Guide for Cisco 910 Industrial Routers
Installation of the Device
translated safety warnings that accompanied this device.
Statement 1071
SAVE THESE INSTRUCTIONS
Warning:
In order to comply with FCC radio frequency (RF) exposure limits, antennas should be located at a
minimum of 7.9 inches (20 cm) or more from the body of all persons.
Statement 332
Warning:
This product relies on the building’s installation for short-circuit (overcurrent) protection. Ensure that the
protective device is rated not greater than: 20A.
Statement 1005
Warning:
The plug-socket combination must be accessible at all times, because it serves as the main disconnecting
device.
Statement 1019
Warning:
This equipment must be grounded. Never defeat the ground conductor or operate the equipment in the
absence of a suitably installed ground conductor. Contact the appropriate electrical inspection authority or an
electrician if you are uncertain that suitable grounding is available.
Statement 1024
Warning:
Only trained and qualified personnel should be allowed to install, replace, or service this equipment.
Statement 1030
Warning:
Ultimate disposal of this product should be handled according to all national laws and regulations.
Statement 1040
Warning:
For connections outside the building where the equipment is installed, the following ports must be
connected through an approved network termination unit with integral circuit protection:
10/100/1000 Ethernet.
Statement 1044
Warning:
To prevent the system from overheating, do not operate it in an area that exceeds the maximum
recommended ambient temperature of:
Statement 1047
140°F (60°C) (with SSD)
140°F (60°C) (without SSD card and in a sealed enclosure)
158°F (70°C) (without SSD card and in a vented enclosure)
Warning:
Installation of the equipment must comply with local and national electrical codes.
Statement 1074
Warning:
To prevent airflow restriction, allow clearance around the ventilation openings to be at least:
3 inches (7.6 cm).
Statement 1076
Warning:
Hot surface.
Statement 1079
Caution:
This industrial router can only be accessed by service personnel or by users who have been instructed
about the reasons for the restrictions applied to the location. Access is through the use of a tool or lock and key, or
other means of security, and is controlled by the authority responsible for the location.
Caution:
Be aware of the size and weight of the Cisco 910 Industrial Router when mounting. Ensure that the
mounting location has a stable flat surface and can safely support the weight of the device.
WARNING
HOT SURFACE
DO NOT TOUCH
390965
