Cisco 7902G - Unified IP Phone VoIP, Administration Manual

Page: 98 / 208

Chapter 4 Configuring Network Settings on the Cisco Unified IP Phone
Configuring IP Settings
4-22
Cisco Unified IP Phone Administration Guide for Cisco Unified CallManager 5.0 (SCCP), Cisco Unified IP Phones
OL-8151-01
Step 6 Press Validat .
Step 7
Press Save .
Assigning a Default Router
If you manually assign an IP address to the Cisco Unified IP Phone, you must
indicate the default router to be used. The default router provides connectivity to
the IP network beyond the subnet to which the phone belongs.
Before you can assign a default router, you must disable DHCP. For instructions,
see the
“Disabling DHCP” section on page 4-17 .
Using the Phone Configuration Web Page (Cisco Unified IP Phone 7902G, 7905G, and 7912G)
Procedure
Step 1
Display the Phone Configuration web page.
For instructions, see the “Accessing Network Settings through a Phone
Configuration Web Page” section on page 4-3 .
Step 2
In the pane on the left under Change Configuration, click Network Parameters .
You may be prompted to enter a password.
The Network Parameters web page appears.
Step 3 To set the route address, enter an address in the StaticRoute field and click Apply .
On the Cisco Unified IP Phone 7902G, you can also review phone settings using
the IVR system. For more information, see
Appendix B, “Using the Interactive
Voice Response (IVR) System on the Cisco Unified IP Phone 7902G.”