Cisco 7902G - Unified IP Phone VoIP, Administration Manual

Page: 168 / 208

Appendix A Additional Configuration Methods and Parameters
Configuration Parameters
A-20
Cisco Unified IP Phone Administration Guide for Cisco Unified CallManager 5.0 (SCCP), Cisco Unified IP Phones
OL-8151-01
Tone Parameters
Table A-6 describes the tone parameters that you can configure through a phone’s
profile file or through its Tone Parameters web page.
Audio Parameters
Table A-7 describes the network parameters that you can configure through a
phone’s profile file or through its Audio Parameters web page.
Table A-6 Tone Parameters
Parameter Description Usage
SigTimer Timeout values for signaling
events. Bit map, as follows:
Bits 0 – 7—Apply to the Cisco Unified IP Phone
7902G only. Interval between each call-waiting tone.
The range is 0 to 255. The setting 0 specifies the
factory default. Any other number specifies the
interval in 0.1 second increments. The default
setting is 100 (0x64, 10 seconds).
Bits 8 – 27—Reserved for future use. Should be set
to 0.
Bits 28 – 29—First repeat interval for the Volume
and Navigation buttons. That is, the button takes
effect the
first time a user presses and holds down the
button for the interval specified. The range is 0 to 3
(0 = one second; 2 = two seconds; 3 = three seconds;
1 disables the Volume and Navigation button repeat
interval). The default value is 0.
Bits 30 – 31—Subsequent repeat interval for the
Volume and Navigation buttons. For example, the
volume increases or decreases when a user continues
to hold down the Volume button for the interval
specified. The range is 0 to 1 (0=0.25 seconds; 1 =
0.50 seconds; 2=0.75 seconds; 3 = one second). The
default value is 0.