4-29
Cisco ASA 5500 Series Hardware Installation Guide
78-17989-01
Chapter 4 Maintenance and Upgrade Procedures
Upgrading Memory in the Adaptive Security Appliance
Figure 4-30
Inserting the DIMM
Caution
When inserting DIMMs, use pressure, but not excessive pressure as this can cause damage to the socket.
Step 5
When you finish installing the DIMM, replace the adaptive security appliance cover. See the
“Removing
and Replacing the Chassis Cover” section on page 4-1
for the procedure.
Step 6
Reinstall the network interface cables.
Verifying the Memory Upgrade
Cisco ASA 5510
You can verify that the memory upgrade has been completed successfully by entering the
show version
command, the example below is for the Cisco ASA 5510 chassis:
hostname#
show version
Cisco Adaptive Security Appliance Software Version 8.0(4)
Device Manager Version 6.1(5)
Compiled on Thu 07-Aug-08 20:53 by builders
System image file is "disk0:/asa804-k8.bin"
Config file at boot was "startup-config"
ciscoasa up 2 days 10 hours
failover cluster up 2 days 11 hours
Hardware: ASA5510, 1 GB RAM
, CPU Pentium 4 Celeron 1600 MHz
BIOS Flash AT49LW080 @ 0xffe00000, 1024KB
Cisco ASA 5520/40
You can verify that the memory upgrade has been completed successfully by entering the
show version
command, the example below is for the Cisco ASA 5520 chassis:
hostname#
show version
Cisco Adaptive Security Appliance Software Version 8.0(0)
Device Manager Version 6.0(0)
Compiled on Mon 16-April-07 03:29 by root
2
2
1
242881
