Cisco 4G-ANTM-OM-CM, Manual

Page: 324 / 535

324
Cisco Multiband Indoor 4G Volcano Antenna (ANT-4G-CM-IN-TNC)

Find someone to help you—installing an antenna is often a two-person job.

Plan your installation carefully and completely before you begin. Each person involved in an installation should be assigned
to a specific task, and should know what to do and when to do it. One person should be in charge of the operation to issue
instructions and watch for signs of trouble.
Antenna Installation
The antenna installation includes the following procedures:

Tools and Equipment Required

Installing the Antenna
Tools and Equipment Required
In addition to the parts included in the antenna kit described in the section Contents of the Antenna Kit , you must provide the
following tool to install the antenna on the router:

Phillips screwdriver

Open-end wrench

Drill

Marker or pencil
Installing the Antenna
Follow these instructions to install the antenna:
1. Determine where on the ceiling you want to install the antenna.
2. Create the center hole to accommodate the 3/4”-16 threaded center rod on the Volcano antenna.
3. Position the Volcano antenna onto the ceiling. Mark on the ceiling the location of the three holes.
4. Remove the antenna and drill the three holes. Place the screw anchors into the holes.
5. Position the antenna in place. Secure the antenna onto the ceiling with the 3 screws using a Phillips #2 screwdriver.
6. From inside the ceiling space, place, in order, the flat washer and curved spring washer onto the center rod. Secure the
antenna with the mounting nut.